INTRODUCTION OF CONTROLLER AREA NETWORK
CAN is Invented by Robert Bosch Gmbh in 1980.
--CAN(Controller Area N/W) is a serial communication protocol,which efficiently supports distributed real time controls with a very high level of security.
--IT is basically for automotive,to reduce the complexcity of wire.
--In Automative electronics,connected using CAN with bit-rates up to 1Mbps.
--The Intension of this specification is to achieve compatibility between any two CAN implementations.
--It is a Asynchronous serial bus.
--Here node addressing is absence.
(a) Message Identifier specifies contents & priority.
(b) Lowest message identifier has highest priority.
(c) Multi-master/Broadcasting concept.
(d) Sophisiticated error detection & handling system,
(e) Industrial & Automotive applications.
CAN is Invented by Robert Bosch Gmbh in 1980.
--CAN(Controller Area N/W) is a serial communication protocol,which efficiently supports distributed real time controls with a very high level of security.
--IT is basically for automotive,to reduce the complexcity of wire.
--In Automative electronics,connected using CAN with bit-rates up to 1Mbps.
--The Intension of this specification is to achieve compatibility between any two CAN implementations.
--It is a Asynchronous serial bus.
--Here node addressing is absence.
(a) Message Identifier specifies contents & priority.
(b) Lowest message identifier has highest priority.
(c) Multi-master/Broadcasting concept.
(d) Sophisiticated error detection & handling system,
(e) Industrial & Automotive applications.
0 comments:
Post a Comment